Author Topic: table bearings issue.  (Read 174 times)

0 Members and 1 Guest are viewing this topic.

Offline G Reiser

  • Member
  • *
  • Posts: 1
table bearings issue.
« on: September 08, 2018, 09:23:28 AM »
I picked up a new eastpointe Newcastle series table for a steal. It will serve my purpose as a fun family type table but the included bushings are incredibly sloppy and make control difficult. It uses standard 5/8 rods and 1" table holes. My question is does anyone have experience with the typical 3 hole screw in bushings that are available from places like brybelly? I want to know if those bushings have a fairly tight fit without being sloppy. I called brybelly but they couldn't give me any info on them.