Chat Area > General Chat

Rod bushing/bearing for 2" thick wall

(1/1)

shaolinmilk:
Hey guys,

I have a pretty crappy table that I turned into a bootleg tornado, however it works for me and has made me better.

The problem I have with my table is the rod bushing/bearing - it moves too much and affects your shot.

I have measured the wall on my table and it is 2"/50mm thick...

I'm unable to find any rod bushing/bearing that fits 50mm... I only see it from 23mm - 26mm.

Can someone help? Thanks!

Cloak:
Had the same issue.   I ordered a set of beatings off Amazon that resembles my old ones.    One half of the bearing worked fine (luckily the half with the bearing itself) the other half was too short.   All I did was use the NEW half with the old half and it worked fine [/img]

shaolinmilk:
Do you have a picture of what you did?

Navigation

[0] Message Index