Thanks for the help gentlemen. As stated the table seems to be in really good shape. The pins were a pain to take out. Luckily I only had to do the two man rods to get the top into the back of the jeep. I did not have a punch pin and used a drill bit. I could not punch any pins out of any handles But was able to get three out of four two rod guys out with ease, the last guy was much more difficult (broke two drill bits hitting with hammer). I did support all rods with wood block before hitting and had cloth between block and playing surface.
Should I get the tool kit? I am thinking yes. I will take pictures once I get it out of the jeep. It was an 90 minute drive back and was late and rainy.
I would like to build a ball return instead of getting it from the goal every time. It seems like there are some folks that have done that. Most nervous about cutting into cabinet.
There was no rust on rods and all moved with ease. There was a bit of rust on leg bolts. Also looked like one end of the cabinet got a bit wet from looking underneath but there is no separation just a bit of staining.
Thanks again
rob