Foosball.com Forums
  1. Foosball.com Forums
  2. Chat Area
  3. General Chat
  4. Topic: Does any one recognize the maker/model of this table?
« previous next »
Pages: [1]   Go Down

Does any one recognize the maker/model of this table?

  • 3 Replies
  • 6830 Views

0 Members and 1 Guest are viewing this topic.

Offline Alexander.win@gmail.com

Does any one recognize the maker/model of this table?
« on: June 30, 2012, 10:22:50 PM »
There are no brand markings on this table. linolium field, metal men, ruber and leather bumpers, metal cross support bars on legs, inch thick plywood on exterior. See the photos on the following link. Any info on this table, manufacture, =- age etc will be appreciated. needs new bumpers.  http://s1145.photobucket.com/albums/o513/win696/

Many Thanks....
« Last Edit: June 30, 2012, 10:39:12 PM by Alexander.win@gmail.com »
Logged

Offline papafoos

  • *
  • 333
  • Good luck reaching me IM, I usually keep them off.
Re: Does any one recognize the maker/model of this table?
« Reply #1 on: July 01, 2012, 09:58:06 AM »
My guess is Rene Pierre, but since I haven't seen one in over 30 years, I'll defer to Alan Cribbs or one of the SE players.
Logged

Offline jagiar

Re: Does any one recognize the maker/model of this table?
« Reply #2 on: July 02, 2012, 09:05:06 AM »
I would also guess Rene Pierre.
Logged

Offline Alan Cribbs

  • 468
Re: Does any one recognize the maker/model of this table?
« Reply #3 on: July 02, 2012, 12:51:59 PM »
It's a RP

Presswood and veneer
Men attached to the rod so when you bend a rod you replace both men and rod.
Single side ball reutrn. Leather like washer beside bumper.

Dealer cost around $450-$550, MSRP anywhere from $995-$1200 new.

Hope that helps some.

Alan
Logged
Pages: [1]   Go Up
« previous next »
  1. Foosball.com Forums
  2. Chat Area
  3. General Chat
  4. Topic: Does any one recognize the maker/model of this table?